Hello, i have some problems with my Purcell, where can i download software to try to reinstall
thanks
I am afraid that being a legacy product and therefore no longer manufactured no software is available from the usual sources. Once a product is withdrawn new software is no longer developed for the model either.
If you have a problem with Purcell you may find help here if you describe it and we know a possible answer. However you may like to contact:
I am asking for old fwd to try to install in Purcell, i need version 2.25 or maybe 2.23 in zip file
Thanks
You asked a similar question in 2023;
In answer @Phil of dCS Support asked you to contact him. I recommended you to contact Support in my reply above. Did you do this?
Theconsumer software updates for the era of Elgar/Delius/Purcell l were made via CDROM which are no longer available. This required a dCS transport with IEE1394 interface. If there is an alternative way of doing this even if you can locate the files I anticipate that you may need advice from dCS Support for advice on using the SUC port.
In any case the AES protocol of Purcel’s time is limited to a maximum sample rate of 96KS/s, To exceed this a dual AES interface is required. However there is only a single AES input. The dual AES interface is an output. Software versions for Purcell up to and including v.2.3 do not affect the AES input. I am unable to find any reference to a v.2.5. or higher.
Hi Pete,
Yes, Raul has contacted us previously regarding his unit and we have been in contact back with him.
Hi @RLRB
I’m afraid there is no later firmware to enable 192kHz support via AES.
I hope that helps.
Phil