Direct connection to Soulution 511 stereo amp

[Anupc (Anup)]

@PAR

Note for @Phil or @James . Researching this I checked the latest Bartok manual ( Doc. DCS311659). This has acceptable input line input as maximum 600ohms and recommended 10-100K. That does not make sense ( at least to me) and maximum should read minimum, no?

The manual is correct. “Maximum” is the right term because it’s a difficult load the lower the impedance gets, hence the use of “maximum”. This was discussed not too long ago

Spec sheet error?

Hi, just noticed a typo in the spec sheet for the Varèse: [Varèse Spec] Er, shouldn’t that be Minimum load?! Same in the specs for all the other products btw, can’t believe I haven’t noticed it before!